d&b V-Series - Manual (Page 41)

6.1. General
To dismantle any of the assemblies described above, follow the
corresponding assembly instructions in reverse order.
The same safety instructions apply.
6.2. Touring cart disassembly
With respect to the touring carts the following procedure is strongly
recommended.
CAUTION!
Potential risk of personal injury and/or
damage to material!
In particular make sure that when lowering the array nobody is
directly underneath or in the vicinity of the array.
When lowering the array onto the cart
avoid diagonal pull.
This could lead to the potential risk of the array tipping over
towards the front.
Depending on the type of surface (arena floor/outdoor field) the
cart could suddenly slide out of position and could cause a
potentially dangerous situation which may lead to personal injury.
1. Dismantle the first cabinet assembly
1. Lower the array to a suitable working height.
2. Release the Safety pin of the Splay link on the lowest cabinet
of the upper assembly.
3. With two persons raise the bottom assembly and fold out the
Splay link of the upper assembly.
4. Carefully lower the bottom assembly.
5. Release all Safety pins of the bottom assembly.
Note: To prevent the Safety pins from getting jammed while
the assembly is lowered onto the cart, reinsert the Safety pins
in one of the remaining holes in the rear rigging strands of the
cabinets.
6. Derigging
d&b V-Series Rigging manual (1.9 EN) 41