d&b V-Series - Manual (Page 32)

5. On the rear rigging strand of the first cabinet, check the splay
angle is set to [0°].
6. Slightly lower the frame and fold in the Splay link into the
strand.
7. Lift the frame until the Splay link hooks into the preset Locking
pin.
8. Insert and lock the second Locking pin (Safety pin) to secure
the Splay link in place.
4. Apply and fix the preset splay angles
The Splay links will be engaged automatically while lifting the
assembly.
1. Slowly lift the cabinet assembly out of the cart until all Splay
links have hooked into the preset Locking pins.
2. Stop lifting and insert and lock the second Locking pins (Safety
pins) to secure the Splay links in place.
Note: In certain cases, the Splay links may not be engaged
automatically. In this case, the Splay angles of the cabinets
should be applied and fixed in the cart before the assembly is
connected to the array. For this purpose, proceed as follows:
4a. Apply and fix the preset splay angles manually
1. Raise the back of the cabinet until the Splay link has hooked
into the preset Locking pin of the bottom cabinet.
2. Hold the cabinet in place and insert the second Locking pin
(Safety pin) to fix the Splay link.
To apply and fix the splay angles of further cabinets, proceed in
the same manner.
d&b V-Series Rigging manual (1.9 EN) 32