d&b V-Series - Manual (Page 28)

3.2.3. Mixed array
NOTICE!
If SUB cabinets are included in the array, these must always be
positioned at the top of the column.
Remarks
For a mixed setup two Flying frames are required. One frame is
used for suspension and the second frame acts as an adapter to
add V8/V12 cabinets below the SUB cabinets.
Since the first part of the setup is similar to the setup of a flown
SUB column as described in , this section only describes the
assembly of the second Flying frame below the SUB cabinets.
Preparations
For this type of setup the Splay link of the second frame must be
attached to «POSITION V8/V12». Check the position and alter it
if necessary as described in Þ Chapter 2.9. " Splay link of the
frame" Þ " Changing the Splay link position" on page 17.
1. Prepare the second Flying frame
To attach the second frame below the SUB cabinets, the two
additional Front links of the frame are needed.
1. Remove the additional Front links together with their Locking
pins from their park positions on the frame.
2. Attach the additional Front links at the top of the front tracks of
the frame and fix them with one Locking pin each.
Note: Observe the direction of attachment as shown in the
graphic opposite.
2. Attach the assembly to the frame
1. Lift the assembly to allow the second frame to be positioned
below the assembly.
2. Position the frame below the assembly.
3. Fold out the Rear link of the SUB cabinet.
Splay link of the frame – «POSITION V8/V12»
d&b V-Series Rigging manual (1.9 EN) 28