BECKHOFF AX2000 PROFIBUS DP communication profile - Manual (Page 13)

2.2.3 Setup Software
2.2.3.1 Screen page PROFIBUS
This screen will only appear, if the PROFIBUS hardware is built into the servo amplifier. The screen
page displays the PROFIBUS-specific parameters, the bus status, and the data words in the trans-
mit and receive directions, as seen by the bus-master. This page is helpful when searching for
errors and commissioning the bus communication.
Baudrate: The baud rate set by the PROFIBUS master.
PNO Identno.: The PNO identification is the number for AX2000/2500 from the list
of ID-numbers set by the PROFIBUS user organization.
Address: Station address of the amplifier (setting see p.8).
PPO type: AX2000/2500 only supports PPO-type 2 of the PROFIDRIVE profile.
PROFIBUS Interface states:
Shows the present status of the bus communication. Data can only be
transferred across the PROFIBUS when the “Communication OK”
message is black (not shown in gray).
Input: The last PROFIBUS object received by the master.
Output: The last PROFIBUS object sent by the master.
The data for input/output are only transferred, if the threshold monitoring for the
AX2000/2500 has been activated in the master’s hardware configuration.
PROFIBUS for AX2000/2500 13
BECKHOFF
12/05
Installation / Setup