Beisler 1281-5 - Manual (Page 76)

2.5.2 Presser foot
Caution: Risk of injury!
Switch the main switch off.
Check and adjust the presser foot only with the sewing unit switched
off.
Standard
The hinges of the hinged sewing foot must be free of clearance and
smooth-running.
The front sewing foot sole 1 and the hind sewing foot soles 4 have to
be in parallel position.
Correction of lateral inclination
–
Remove the front sewing foot sole 1.
– Bring the head into position “needle down”.
– Place two approx. 5 mm wide paper strips 5 next to each other
under the hind sewing foot sole 4.
– Adjust the lateral inclination in such a way that the inner paper strip
is clamped a little less than the outer one and can be easily pulled
out of the clamping of the sewing foot.
Compensation of the front and hind sewing foot sole
–
Remount the front sewing foot sole 1.
– Bring the head into position “needle down”.
– Turn the setting screw 3 in such a way that the front sewing foot
sole just rests on.
Inclination of the front sewing foot sole
The whole length of the front sewing foot sole should rest on the throat
plate in the position “needle down”.
–
Set the sewing foot sole with screw 2.
14
4 3 2 1 5 4