Comtech EF Data RSU-503 - Manual (Page 20)

Installation RSU-503 Redundancy Switch Unit
4 Rev. 8
2.3 Switch Installation
At the customer’s discretion, the switch can be installed anywhere on or near the
antenna. The supplied hardware allows the installer a wide range of installation
alternatives, including:
•
Vertical pole (e.g., mast) (either square or round). This is the most typical
installation.
•
Within the hub of a large antenna.
•
Spar (i.e., rectangular bar) on the antenna structure.
The switch is designed to be mounted with the interface connections facing the ground.
Note: For custom installations, refer to Figure 2-1 for dimensions of the RSU-503.