Datatek UMI - Manual (Page 55)

U N I V E R S A L M E D I A T I O N I N T E R F A C E ( U M I ) U S E R M A N U A L
04/30/09 55
1 0 A P P E N D I X C : A L A R M S
This appendix is an enumeration of the alarms presented on the UMI console along with their
severity.
Alarm Severity
Tx Error on 10BaseT. Check Physical Connection.
MAJOR
Insufficient Buffers for FRAME RELAY LMI Status Report. MAJOR
User Requested Reboot in Progress INFO
Invalid Login Attempt. MINOR
Invalid Password Change Attempt. MINOR
SNMP Trap Manager not reachable (ICMP). INFO
ICMP Destination Unreachable Msg Received. MINOR
Tx Error on Serial Interface MAJOR
Over-Temperature Condition Detected. MAJOR
Over-Temperature Condition Cleared. INFO
High Temperature Condition Detected. MINOR
High Temperature Condition Cleared. INFO
Port XXX received a call from XXX.XXX.XXX.XXX outside CUG list. MINOR
Serial Number is not valid. Module defective. MAJOR
ATM Receiver never Synchronized. INFO
Installation Attempt Failed. MINOR
Console session in-activity timeout. INFO
Vport XXX disconnected. Half Open TCP error. INFO
DTK41 10/100 BaseT PHY #N ‘Link Active’. MINOR
DTK41 10/100 BaseT PHY #N ‘Link InActive’. MINOR
DTK41 Fiber ‘Link Active’. MINOR
DTK41 Fiber ‘Link InActive’. MINOR
10.1 Major Alarms
A major alarm indicates a serious, service-degrading condition.
10.2 Minor Alarms
A minor alarm indicates a secondary or transient error that is not likely to affect overall service
unless multiple minor alarms are issued. In this case, a serious condition exists that may affect
overall system performance
10.3 Info Alarms
An information alarm is a message that does not necessarily require attention. It typically is
important for network administration, but does not adversely affect service.