DR Power 3-Point Hitch Rapid-Feed - Manual (Page 22)

18 3-POINT HITCH DR ® RAPID-FEED™ CHIPPER
4. Measure and cut each Shaft Tubes to the required
length using the hacksaw (Figure 19).
5. File or sand any burrs from the Shaft ends (Figure 20).
6. Grease both Shaft Tubes and under the Bearing Rings
of each Shaft (Figure 21).
Shaft
Tube
End
Figure 20
Shaft Tube
Figure 19
Bearing
Ring
Figure 21
Shaft
Tube