DR Power 3-Point Hitch Rapid-Feed - Manual (Page 25)

CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 21
CHAPTER 4
OPERATING YOUR 3-POINT HITCH DR RAPID FEED
CHIPPER
This chapter covers the procedures for starting and stopping your new 3-POINT HITCH DR RAPID
FEED CHIPPER and discusses basic operation features.
Starting the Chipper
1. Ensure that the Chipper is lowered to the ground and all Guards are in place and properly secured
before using.
2. Remove any debris buildup from the machine before every use of the Chipper.
3. Set Tractor throttle at IDLE before engaging PTO with Chipper attached.
4. Increase Tractor throttle to the RUN RPM’s required to obtain 540 PTO speed before chipping.
5. Reduce Tractor throttle to IDLE before disengaging PTO.
NOTE: Check the Drive Belt, if necessary, after an initial break-in period of one (1) hour (see Chapter 5
“Maintaining the 3-POINT HITCH DR RAPID FEED CHIPPER”).
• THIS MACHINE IS DESIGNED TO OPERATE AT 540 RPM ONLY! NEVER OPERATE THE MACHINE AT A
FASTER SPEED; DOING SO CAN CAUSE SERIOUS INJURY TO THE OPERATOR OR BYSTANDERS AND
COULD CAUSE DAMAGE TO THE MACHINE THAT IS NOT COVERED UNDER WARRANTY.
• THE DR 3-POINT HITCH CHIPPER MUST BE OPERATED WITH THE WEIGHT OF THE MACHINE ON
THE GROUND. OPERATING THE MACHINE WHILE IT IS OFF THE GROUND CAN RESULT IN INJURY
TO YOURSELF OR OTHERS, AND CAN CAUSE DAMAGE TO THE MACHINE WHICH IS NOT COVERED
UNDER WARRANTY.
• THE DESIGN OF THIS MACHINE IS FOR CHIPPING WOOD. NEVER USE THIS MACHINE FOR ANY
OTHER PURPOSE AS IT COULD CAUSE SERIOUS INJURY.
• CONTACT WITH INTERNAL ROTATING PARTS WILL CAUSE SERIOUS PERSONAL INJURY. NEVER PUT
HANDS, FACE, FEET, OR CLOTHING INTO CHIPPER HOPPER OR DISCHARGE OPENING OR NEAR
THE DISCHARGE AREA OR PTO SHAFT AT ANY TIME.
• DISENGAGE PTO, SHUT DOWN THE TRACTOR ENGINE, REMOVE THE KEY, WAIT FOR ALL MOVING
PARTS TO COME TO A COMPLETE STOP, DISCONNECT THE PTO SHAFT FROM THE TRACTOR, THEN
WAIT 5 MINUTES BEFORE MOVING OR PERFORMING MAINTENANCE/INSPECTION ON THE
CHIPPER. USE ONLY A WOODEN STICK TO CLEAR JAMMED MATERIAL.
• NEVER OPERATE THE MACHINE WITHOUT THE HOPPER OR DISCHARGE CHUTE OR PTO SHAFT
PROPERLY INSTALLED.