DR Power 3-Point Hitch Rapid-Feed - Manual (Page 29)

CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 25
CHAPTER 5
MAINTAINING THE 3-POINT HITCH DR RAPID FEED
CHIPPER
This chapter covers regular maintenance procedures that will ensure the best performance and long life
of your 3-POINT HITCH DR RAPID FEED CHIPPER.
Maintenance Kits and Accessories are available through our website at www.DRpower.com.
Regular Maintenance Check List
NOTE: Consider that the service intervals shown are the maximum under normal operating conditions.
Increase frequencies under extremely dirty or dusty conditions. See the Owners Manual that came
with the Tractor and with the PTO Shaft for Specific Tractor and PTO Shaft maintenance.
Procedure
Before
Each Use
Every 8-10
Hours
Every 18-20
Hours
Every 40
Hours
Check General Equipment Condition
▲
Check that the Flywheel turns freely (with a long
stick only)
▲
Visually inspect Knife for damage
▲
Check Knife and Wear Plate for Sharpness
▲
Check Knife and Wear Plate Attachment Screws
▲
Check Flywheel Bearing Collar Set Screws
▲
Check Knife to Wear Plate Gap
▲
Lubricate Flywheel Bearings
▲
Lubricate PTO Shaft Grease Fittings
▲
Lubricate PTO Sheave Bearings
▲
Check Belt Tension and Condition
1 st time 1
hour
▲
Lubricate PTO Shaft Spline ends and center overlap
▲
Inspect or replace Drive Belt
▲
DISENGAGE PTO, SHUT DOWN THE TRACTOR ENGINE, REMOVE THE KEY, WAIT FOR ALL MOVING PARTS
TO COME TO A COMPLETE STOP, DISCONNECT THE PTO SHAFT FROM THE TRACTOR, THEN WAIT 5
MINUTES BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE CHIPPER.