Flowserve M-series PolyChem - Manual (Page 11)

USER INSTRUCTIONS PolyChem M-SERIES ENGLISH 71569218 07-11
flowserve.com
Page 11 of 60
®
2.3.2 Lifting pump, motor and baseplate
assembly
If the baseplate has lifting holes cut in the sides at the
end (Type D and Type E bases) insert lifting S hooks at
the four corners and use slings or chains to connect to
the lifting eye. Do not use slings through the lifting
holes.
For other baseplates, sling around the pump discharge
nozzle, and around the outboard end of the motor frame
using choker hitches pulled tight. (Figure 2-1)
The sling should be positioned so the weight is not
carried through the motor fan housing. Make sure the
completion of the choker hitch on the discharge
nozzle is toward the coupling end of the pump shaft
as shown in Figure 2-1.
2.4 Storage
Store the pump in a clean, dry location
away from vibration. Leave flange covers in place to
keep dirt and other foreign material out of pump
casing. Turn the pump shaft at regular intervals to
prevent brinelling of the bearings.
The pump may be stored as above for up to 6
months. Consult Flowserve for preservative actions
when a longer storage period is needed.
2.4.1
Short term storage and packaging
Normal packaging is designed to protect the pump
and parts during shipment and for dry, indoor storage
for up to six months or less. The following is an
overview of our normal packaging:

All loose unmounted items are packaged in a
water proof plastic bag and placed under the
coupling guard

Inner surfaces of the bearing housing, shaft (area
through bearing housing) and bearings are coated
with Cortec VCI-329 rust inhibitor, or equal.
Bearing housings are not filled with oil prior to
shipment

Regreasable bearings are packed with grease
(EXXON POLYREX EM)

Exposed shafts are taped with Polywrap

Flange covers are secured to both the suction
and discharge flanges

In some cases with assemblies ordered with
external piping, components may be
disassembled for shipment

The pump must be stored in a covered, dry
location
2.4.2 Long term storage and packaging
Long term storage is defined as more than six
months, but less than 12 months. The procedure
Flowserve follows for long term storage of pumps is
given below. These procedures are in addition to the
short term procedure.

Each assembly is hermetically (heat) sealed from
the atmosphere by means of tack wrap sheeting
and rubber bushings (mounting holes)

Desiccant bags are placed inside the tack
wrapped packaging

A solid wood box is used to cover the assembly
This packaging will provide protection for up to twelve
months from humidity, salt laden air, dust etc.
After unpacking, protection will be the responsibility of
the user. Addition of oil to the bearing housing will
remove the inhibitor. If units are to be idle for extended
periods after addition of lubricants, inhibitor oils and
greases should be used. Every three months, the pump
shaft should be rotated approximately 10 revolutions.
2.5 Recycling and end of product life
At the end of the service life of the product or its
parts, the relevant materials and parts should be
recycled or disposed of using an environmentally
acceptable method and in accordance with local
regulations. If the product contains substances that
are harmful to the environment, these should be
removed and disposed of in accordance with current
local regulations.
Make sure that hazardous substances are
disposed of safely and that the correct personal
protective equipment is used. The safety
specifications must be in accordance with the current
local regulations at all times.