Gasboy TopKAT Operation Manual - Manual (Page 38)

Getting Started/System Setup Accessing the Main Menu Options
Page 30 MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009
Accessing the Main Menu Options
To access the Main Menu Options, proceed as follows:
1 Insert and turn the Manager key.
2 Enter the password. The COMMAND: SETUP prompt displays.
3 Use the up and down arrow keys to scroll through the menu choices: SETUP, REPORTS,
DIAGNOSTICS, and UTILITIES.
Setup Menu
Accessing the Setup Commands
To access the Setup Commands, proceed as follows:
1 Access the Main Menu. When COMMAND: SETUP appears, press ENTER.
2 Use the up and down arrow keys to scroll through the SETUP commands. Press ENTER when
the required command is displayed.
3 Type any command input and press ENTER again.
4 Repeat steps 2 and 3 as needed. To exit from the SETUP commands, press PREV as many
times as necessary.
5 Use the up and down arrow keys to scroll through the main menu choices.
STOP (only for Master and Standalone Modes)
Use STOP to stop the fuel site. All ongoing transactions are terminated and site is stopped
until a RUN command is issued. This command is valid only from the master unit in master/
satellite combinations. When the system is stopped, OUT OF SERVICE displays on the
master and all satellite displays.
RUN (only for Master and Standalone Modes)
Use RUN to start (or re-start after a stop) the site. During initial system power-up, if all
essential system operating data is not correct, the system will not start and will have to be
started with the RUN command after the fault conditions are corrected. This command is valid
only from the master unit in master/satellite combinations.
LOAD MODE
Use LOAD MODE to select the operating mode for the TopKAT. Available choices are
STANDALONE, MASTER, or SATELLITE. This option must be set individually at the
master and at each satellite. When the mode is changed, you are prompted to confirm the
change.