Gasboy TopKAT Operation Manual - Manual (Page 89)

MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009 Page 81
Accessing the Terminal Diagnostics Menu Diagnostics and Utilities
2 Select the required option.
• Single Pass executes one pass through the test and stops. The Test Count/Fail display is
updated after each pass. If the Stop/Start option is selected, the status line indicates the
system is stopped. Pressing Stop/Start again displays the previous final test status. In the
single pass mode, if the test stopped because of errors, the Fail indicator will be
incremented by one.
• Continuous Passes continually runs successive test passes until one of the other options is
selected. The Test Count/Fail display is updated after each pass. In continuous pass mode,
Stop/Start completes the test that is currently running or restarts testing when pressed
again.
• Restart test option re-initializes the Test Count/Fail display, then executes the last
selected test option.
Terminal: DIP SWITCH TEST
Use this option to initiate a display showing the current position of each DIP switch (SW1) on
the CPU PCB. When a switch position is changed, the display reflects that change.
1 On the diagnostic Main Menu, select DIP SWITCH TEST.
The DIP switch display appears (see
Figure13-1 ), followed by the message
“Press any key for Main Menu.”
Figure 13-1: DIP Switch Display
----------------------- OPEN ----------------------
S1
1 2 3 4 5 6 7 8
2 When a switch position is changed, the display reflects that change. Press any key to return to
the diagnostics Main Menu.
Terminal: HEALTH LIGHT TEST
Use this option to check the status of the yellow health light located on the CPU board.
1 On the diagnostic Main Menu, select HEALTH LIGHT TEST.
The Health Light Test Menu appears:
HEALTH LIGHT TEST
1. TURN HEALTH LIGHT ON
2. TURN HEALTH LIGHT OFF
3. READ HEALTH LIGHT STATUS
4. QUIT TO MAIN MENU