Hypertherm Duramax Hyamp Long Handheld Torches - Manual (Page 47)

Duramax Hyamp Long Handheld Torches Service Manual 808290 47
4 – Component Replacement
Replace the front shell
Remove the front shell
Several replacement procedures for the Duramax Hyamp long handheld torches require the removal of the front shell that
surrounds the torch head. To replace the front shell, you need to remove the torch head and cap-sensor switch from the
shell.
1. Turn OFF (O) the power, disconnect the gas supply, and disconnect the torch.
2. Remove the consumables from the torch.
3. Place the torch on a flat surface with the left front shell facing up.

The left shell is the side with the screws.
4. Clamp the torch lead in place to keep it from moving.
5. Remove the screws from the left front shell.
6. Lift the left side of the front shell away from the torch.
Figure 7
Kit Description
428278 Kit: Duramax Hyamp 45° long handheld torch front shell replacement
428279 Kit: Duramax Hyamp 90° long handheld torch front shell replacement