Hypertherm Duramax Hyamp Long Handheld Torches - Manual (Page 50)

50 Duramax Hyamp Long Handheld Torches Service Manual 808290
4 – Component Replacement
6. Route the cap-sensor wires as shown in Figure 10.
 45° torches: Position the wires above the gas tube and above the protective foam that is wrapped around the
gas tube.
 90° torches: Position the wires underneath (or behind) the gas tube and below the protective foam that is
wrapped around the gas tube.
Figure 10 – Wire routing in 45° (top) and 90° (bottom) front shell
1
2 3
1
45°
90°
1 Slot for torch head
2 Cap-sensor switch
3 Slot for foam strip wrapped around the gas tube