Hypertherm Duramax Hyamp Long Handheld Torches - Manual (Page 49)

Duramax Hyamp Long Handheld Torches Service Manual 808290 49
4 – Component Replacement
Install the front shell
1. Make sure that the pilot terminal screw on the torch head is tightened to 17.3 kg∙cm (15 inch∙pounds).
2. Make sure the consumables have been removed from the torch.
3. Lay the right side of the front shell on a flat surface with the inside facing up.
4. Clamp the torch lead in place to keep it from moving.
5. Press the cap-sensor switch into its post hole and onto its mounting post in the shell.
Figure 9 – Install cap-sensor switch in 45° (top) and 90° (bottom) front shell
45°
90°