Marantz SR5004 - Manual (Page 53)

NAMES AND FUNCTIONS
51
BASIC
CONNECTIONS
BASIC
OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
ADV
ANCED
OPERA
TION
ENGLISH
ADVANCED OPERATION
PRESET SCAN
2.
1.
3.
6.
5.
1. Press the TUNE button twice within two
seconds on the remote controller.
2.
Press the BAND button to select XM band.
3.
Press the P.SCAN button on the remote
controller.
4. Preset channels are recalled in sequence
(No.1 → No.2 → etc.) for about 10 seconds
each. The time changes by the received
condition. No stored preset number will be
skipped.
5. Pressing the 2 button during prescanning
speeds up scanning.
Also, pressing the 1 button returns to the
previous preset channel.
6.
When the desired preset channel is
received, cancel the preset scan operation
by press the P. SCAN button.
CLEARING STORED PRESET CHANNELS
You can remove preset channels from the memory
using the following procedure.
2.
3.
2. 3.
1.
Recall the preset number to be cleared with
the method described in “PRESET SEARCH
MODE”.
2.
Press the MEMORY button on the front
panel or press the MEMO button on the
remote controller.
3.
The stored preset number blinks in the
display for 5 seconds. WhiIe blinking, press
the CLEAR button on the front panel or CLR
button on the remote controller.
4.
“xx CLEAR” appears on the dispIay to
indicate that the specifi ed preset number
has been cleared.
Notes
• To clear all stored preset channel, press and hold
the T.MODE and the ENTER buttons on the unit
for two seconds.
• There are 50 preset channels prepared at the
factory default. The 50 channels are all set to
“CHANNEL 001”. Each channel can be stored
in the preset memory. You can search for only the
preset channels.
LISTENING TO
SIRIUS SATELLITE RADIO
SELECTING AN INPUT SOURCE
Before you can listen to SIRIUS Satellite Radio, you
must fi rst select the input source on the unit.
1. 2.
1.
2.
(Using the unit)
1. Turn the INPUT SELECTOR knob to select
“TUNER”.
2. Press the BAND button to select SIRIUS.
(Using the remote controller)
1.
To select tuner, press the TUNE button
twice within two seconds on the remote
controller.
2.
Press the BAND button to select SIRIUS.
CHECKING THE SIRIUS SIGNAL
STRENGTH AND RADIO ID
2.
1.
1. Press the TUNE button on the remote
controller.
2. Press the T.DISP button 3 times to display
the signal status on the front display of the
unit.
S R S A T :
S R T E R R :
• The top line of the display shows the strength
of the signal received from satellite, while the
bottom line displays the strength of the terrestrial
signal received.
• An mark indicates the strength of the stronger
of the satellite and terrestrial signals.
• The display changes as shown below according
to the receiving condition.
EXCELENT display
S R :
GOOD display
S R :
WEAK display
S R :
NO SIGNAL display
S R :