NewTek 3Play 330 - Manual (Page 27)

Page 21
2. Connect 3P LAY ’s audio outputs:
a. Analog audio - Connect external audio devices to the 1/4 inch (6.3mm) balanced
phone jacks beside each video input section.
b. Digital audio - A separate audio connection is not necessary for SDI output with
embedded audio. Use the BNC connectors in the Digital Audio Out section only
to connect downstream AES3 (AES/EBU) audio devices.
4.4.3 I/O CONFIGURATION
At this point, you can configure the audio and video sources you have connected. Some other
settings can be considered now as well (such as what type of output connection you require).
1. Open a 3P LAY session from the Administration Screen.
2. Access the I/O Configuration panel (Figure 7) by clicking the small ‘gear’ icon located at
upper-right in the titlebar of the 3P LAY Desktop.
3. Select the correct Video Connection and Audio Connection types from the drop-down
menus for each source you connected to 3P LAY ’s inputs.
4. Set the correct Output>Video Connection type for your external analog monitor(s) or
other downstream systems.
Figure 7