Orion System HB Controller - Manual (Page 14)

Zone
Zone
Programming
14 HB Controller Technical Guide
Entering Passcodes
The HB Service Tool is used to program setpoints and view the status
of the HB controller. It is connected to the HB controller by means of
a modular cable. The cable is connected between the HB Service Tool
and the HB controller board. The HB Service Tool doesn’t require bat-
teries or a separate power source, because all power to operate the HB
Service Tool is provided through this cable. The HB controller must be
powered in order for the HB Service Tool to function.
Device Address
064
When the HB Service Tool is initially powered up, the program version
and the current time and date will be displayed. After the initial power
up, this screen only appears when the HB power is removed and then
reapplied. Press ENTER, and the HB Service Tool will check all current
parameters. When it has fi nished this checking procedure, press ENTER,
and the main HB programming screen will be displayed. If you want
to change setpoints, you will need to enter a passcode at this time. If
you only want to view status, a passcode is not required, and you can
proceed to view status directly by pressing the ENTER key.
If you want to change the Passcode, hold down on the UP and DOWN
SELECT ARROWS simultaneously and the following screen will be
displayed.
Enter Code
AAA A
The passcode entry screen uses a four-digit alpha passcode. Position
the cursor under the fi rst letter fi eld. To select the desired letter, use the
ADJUST ARROWS. The UP arrow increases through the alphabet and
the DOWN arrow decreases. When the desired letter appears, press the
RIGHT ARROW key to advance to the next letter fi eld. Once all four
letter fi elds spell the desired passcode, press the ENTER key.
Available passcodes are:
● “OPER” = The Operator is at level 1 for Status and
Setpoints
●
“CONT” = The Contractor is at level 2 for Status, Setpoints
and Force Modes
Again, if no passcode is entered, the default level is 0 and only allows
viewing of the status screens.
General Procedures
When the HB Service Tool is initially powered up, this screen will be
displayed. Press ENTER to proceed to the next screen.
Enter your passcode as described in the previous section and proceed by
pressing the MENU key. The following screen will be displayed:
Line #2 displays the default address for the HB Controller. If equipped
with a MHGRV Controller, adjust the address to 065 in a similar fashion
as you did when you entered your passcode. Once you have the desired
address on the screen, press the ENTER key. The following screen will
be displayed:
Line #2 displays the controller name or program name. Press the ENTER
key to advance.
Module Selection Screens
After pressing ENTER in the previous step, the fi rst available program-
ming module screen appears. All of the HB controller Status and Set-
point Screens are grouped in specifi c modules designated by a specifi c
function name.
Using the select arrows, scroll to select the desired module on line #1
and press the ENTER key.
Programming with the HB Service Tool