Introduction, Overview, Network setup – QVidium QVSD User Manual
Page 4: 1 overview, 2 network setup
User‟s Manual v.3
QVidium
®
QVSD H.264 SD Video
Codec™
Copyright 2011 QVidium
®
Technologies, Inc.Page 4 of 53
1
Introduction
Congratulations on purchasing the QVidium
®
QVSD H.264 SD Video Codec
™.
QVidium
®
QVSD H.264 SD Video Codec
™ – Front View
1.1 Overview
The QVidium QVSD H.264 SD Video
Codec™ can encode, decode, or transcode standard or high
definition video using either MPEG2 (main profile) or MPEG4-AVC (Part 10, H.264 High Profile,
Level 4.1) compression, and to interface a video feed from a wide range of video standards and
connections for transport over nearly any IP network. The H.264 SD Video
Codec™ includes
QVidium‟s patented, advanced ARQ Error Correction and clock synchronization. With these
advanced Quality of Service (QoS) features, the H.264 SD Video
Codec™ can send video over
nearly any network and across the world, including wireless connections and the public Internet,
with unsurpassed video transport quality and state-of-the-art video compression for minimizing
bandwidth.
1.2 Network Setup
The H.264 SD Video
Codec™ comes with a factory preset IP address of 192.168.1.23 and
Netmask of 255.255.255.0. You can download and run our CodecManager application to
determine or change the IP settings, even when the IP address has been reset to an unknown
address. Please refer to Section 8 of this manual for configuration using the CodecManager
application.
The H.264 SD Video
Codec™ can also be reconfigured through a web browser when you know
the IP address. Follow the steps below to reconfigure the network settings through a web browser
on a computer connected to the same subnet as the Codec.
1) Point your web browser to
NOTE: The H.264 SD Video
Codec™ requires user authentication to enter the web browser or to
log in using Telnet. The factory preset username
is “root” and the password is also “root.”
Please enter these settings when prompted to access the system.