REMKO WPM-Smart-Control-Manual for specialists-WKF-085 - Manual (Page 12)

"3D house" animation
Once the Smart-Control commissioning wizard has
been completed, you will see the home screen with
the 3D house. Pressing the left softkey starts the
animation. To return to the home screen with the
3D house, press "Cancel" (left softkey).
Overview
Next view Start animation
Fig. 13: 3D house
To immediately display temperatures in the
system, you can press "Next view" (right softkey).
This is an overview of the key system data, repre-
sented using a 3D house.
2
Fig. 14: Explanation of View 1
1: Collector array
2: Heat pump outdoor unit
Fig. 15: Explanation of View 2
1: Conv. heat generator
2: Solar storage tank (primary)
3: Storage tank 2
4: Boiler (solid fuel)
5: Radiator
Explanation of operating statuses:
Circuit is in operation
Hot water or heating is being heated by solar
energy
The heat pump is in operation
The heating is being provided by conventional
means
Hot water dispensing active
Explanation of other icons:
Manual operation (probe / actuator)
Error raised
Warning raised
Current measured values, such as temperature or
output, are displayed. The lines refer to the indi-
vidual components.
The charging status of the storage tank is specified
in percent. 100% means that the solar volume of
the storage tank is fully charged.
If a photovoltaic system is integrated, the following
values can be displayed.
Fig. 16: Explanation of View 3
1: Heat pump power
2: Domestic power supply
3: PV current
Depending on the level of equipment purchased
for the system, some components may not be dis-
played in the 3D house. It is also possible that
some components will be displayed which are not
present. However, for such components, no tem-
perature or operating statuses are shown.
REMKO Smart WP MANAGER
12