REMKO WPM-Smart-Control-Manual for specialists-WKF-085 - Manual (Page 14)

Favourites menu: for the user
Using the rotary knob (turning it clockwise) you can
access other views. They allow you to rapidly and
easily adjust the most important parameters and
view the yield in kilowatt hours and weather infor-
mation.
Hot water
The Storage tank set temperature (set with the
left softkey, then confirm with "OK") is the tempera-
ture to which conventional reheating should heat
the storage tank to ensure comfortable conditions.
If there is a solar yield, the storage tank can
become substantially warmer. The maximum tem-
perature for solar charging can be modified under
Settings/Solar/Storage tank. For efficiency rea-
sons, the lowest possible set temperature should
be selected. If the available quantity of hot water is
insufficient, the value should be increased. Pay
attention to the maximum temperature of the heat
generator while doing so.
The Mode (select with the right softkey, then con-
firm with "OK") for hot water preparation can be set
as follows:
Automatic comfort: Hot water preparation always
takes place according to the setpoint, i.e. no opti-
misation of the solar yields.
Automatic eco: In order to optimise the solar yields,
during solar storage tank charging, the set temper-
ature of the storage tank is reduced by the "Toler-
ance during solar operation". This delays the
reheating of the storage tank or, where the solar
output is sufficient, prevents it.
Solar only: The hot water is heated exclusively by
solar, i.e. if the temperature drops below the set
temperature, no conventional reheating takes
place.
Fig. 20: Hot water
Then turn the rotary knob clockwise.
Room climate
Colder/Warmer can be used to adjust the temper-
ature of the heating (set with the left softkey, then
confirm with "OK"). If the room temperature is too
low, the room thermostat (on the heater) should
first be set higher. If this is not sufficient, then set
the Warmer/Colder value higher by 1°C. This also
roughly corresponds to one degree of room tem-
perature.
Room climate mode (select the right softkey, then
confirm with "OK") allows you to define the oper-
ating status of the room heater.
Automatic (recommended): the mode switches
automatically between heating, standby and
cooling (special equipment), based on the outside
temperature. This takes account of the ability of
the building to retain heat. For example, on cooler
summer nights the room heater stays off, pre-
venting unnecessary operation.
Heating: heating mode occurs in accordance with
the outside temperature and the heating curve
(weather-controlled).
Standby: in standby mode neither heating nor
cooling occurs, however anti-freeze protection is
active.
Cooling: cooling mode occurs in accordance with
the outside temperature and the cooling curve
(weather-controlled).
Fig. 21: Room climate
Then turn the rotary knob clockwise.
REMKO Smart WP MANAGER
14