Remotec ZTS-110 V3.14 - Manual (Page 41)

41
COMMAND_CLASS_BATTERY NO YES
COMMAND_CLASS_BASIC YES YES
COMMAND_CLASS_VERSION NO YES
COMMAND_CLASS_MANUFACTURER_SPECIFIC NO YES
COMMAND_CLASS_ASSOCIATION NO YES
COMMAND_CLASS_CONFIGURATION NO YES
Checking Accessories
After opening the cover of the packing box, check that the following accessories are included.
• ZTS‐110: Z‐Thermostat
• Screw + Wall Anchor x 4pcs
• RC/RH jumper wire x 1pc
• AA batteries x 4pcs (optional)
• User Manual
• Warranty sheet
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐ Consult the dealer or an experienced radio/TV technician for help.
Notice : Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.