Remotec ZTS-110 V3.14 - Manual (Page 8)

8
Wiring:
z Be sure the operation mode is OFF and Fan selection is Fan Auto
z Wire the proper cables at the terminal block according to the circuit diagram
z Afterward, push all cables back into the wall
z Do not use metal conduit or of cable provided with a metal sheath
z Recommends adding fuse or protective device in the line circuit
Terminals Symbol
Cool changeover (heat pump) O
Heat changeover (heat pump) B
2nd Stage heater W2
1st Stage heater W1
Fan G
Compressor Y
24Vac Power for Cooling RC
24Vac Power for Heating RH
24Vac Common C