Rena Envelope Imager 3.0 - Manual (Page 14)

SECTION 1
GETTING ACQUIANTED
Section 2 – Printer Installation and Setup
Before using the printer, the following must be done:
• Choose a location for the printer
• Connect power to the printer
• Connect it to the computer
• Install the Inkjet Cartridges
• Set up the feed system (media separation and transport) on the printer
• Position the Print Units
Choose a Location
The printer should be placed on a sturdy worktable or cabinet at least 12 inches from any walls.
Protect the printer from excessive heat, dust, and moisture – avoid placing it in direct sunlight.
Connecting Power to the Printer
1. Make sure that the main power switch of the Printer is in
the OFF (0) position.
2. Verify that the power source is the correct voltage for your
printer, and it is properly earth grounded. The use of a surge
protector is recommended.
3. Connect one end of the power cord to the rear of the Printer
in the corresponding receptacle.
4. Plug the other end into a 115 Volt AC, 50/60 Hz. Grounded
outlet.
CAUTION
Do not use an adapter plug or extension cord to connect the
printer to the wall receptacle.
Figure 10
Do not use outlets controlled by wall switches.
Do not use an outlet that shares the same circuit with large electrical machines or appliances.
Surge Protectors are recommended.
Connecting to the Computer
ƒ USB Users: Plug the USB cable from your
computer, into the printer’s USP USB Port,
located next to the parallel port connector.
ƒ Parallel Users: Plug the parallel printer cable
from your computer into the printer’s Parallel
Port and latch the two locking clips.
NOTE: The cable used to connect the printer to the
computer must not exceed 6 feet long. The parallel port may be used for all versions of Windows. The
USB Port is used only for Windows ME, 2000, and XP. Figure 11
14
Envelope Imager 3.0/4.0 Operations Rev. 6/7/2007