Rena Envelope Imager 3.0 User Manual
Page 6
SECTION 1
GETTING ACQUIANTED
Packaging/Shipping
The printer is shipped in appropriate packaging so that, under normal shipping conditions, it
reaches its destination without damage.
NOTICE: Report damage to the carrier. The carrier is liable for any damage during transport. Transport
and storage should take place under normal conditions, i.e. at temperatures between +5°C and +70°C and
relative air humidity of up to 80%. Exposure to conditions that are not permissible may lead to damage
which is not externally visible.
Please save the packaging for future use! It will be required if you ever need to ship the printer.
Contents
The following items are included with your printer:
1 Power Cord
2 Media Side Guides (mounting hardware attached to printer)
1 Rear Paper Support (mounting hardware attached to item)
1 Rear Media Guide (attached to Rear Paper Support)
1 Rear Media Guide Extension (replaces standard guide plate, when using long media)
1 Magnetic Media Side Guide Extension (can be attached to the side of a Media Side Guide)
1 Driver Installation CD ((Operations Manual (PDF) included on this CD))
Note: The printer drivers on this CD have been tested and approved by Rena Systems.
Note: Parallel and USB interface cables and Ink cartridges are not included with the printer.
Interface USB cables (recommend 6 ft or less) can be purchased from computer and office supply
stores.
Ink cartridges can be purchased through your local Rena dealer.
Figure 1
6
Envelope Imager 3.0/4.0 Operations Rev. 6/7/2007