Rena Envelope Imager 3.0 - Manual (Page 36)

SECTION 3
OPERATING THE PRINTER
Printing from Satori Bulk Mailer® 5.0
Printer Drivers: Satori has developed their own printer drivers for use with their software
product. Therefore, Satori recommends that you load and use the printer drivers available to you
on the Satori Bulk Mailer 5.0 CD. If not, the Bulk Mailer software may not function properly with
the printer.
The following is a brief description of how to setup and print from Bulk Mailer 5.0.
1. Open Bulk Mailer 5 and select (open) the mailing list of your choice.
2. Use the Bulk Mailer 5 "Wizards" to setup your job.
This newer version of Bulk Mailer is driven by "Wizards", which will guide you through the envelope
design and layout process.
Your envelope design (layout) should look similar to the one shown below.
This example was designed for the Envelope Imager 1.5. Notice how the address data is positioned at
the top of the page, within the first 1.5 inches of the top of the page. When using the Envelope Imager
3.0, it can accommodate print on the first 3 inches of the page. When using the Envelope Imager 4.0, it
can accommodate print on the first 4 inches of the page.
3. Click on the "Go to Preview Mode" icon , located at the upper left-hand corner of the Bulk
Mailer 5 "designer" screen.
Tip: Click on the "Go to Designer Mode" icon , to return to the "designer" screen.
36
Envelope Imager 3.0/4.0 Operations Rev. 6/7/2007