Verilink PRISM 3101 (34-00212) Product Manual - Manual (Page 25)

Configuration 3-9 PRISM 3101/3102
Near Loops: Displays the loop status of the near element.
Far Loops: Displays the loop status of the far element.
Configuration Screens
The Configuration screens allow you to view and set config-
uration parameters for the network elements.
To send a new configuration to the unit, you
must press <return> on one of the fields or exit
the screen. The underlined values are the factory
default parameters.
Table 3-I Status Indications
Status Description
------- No status is available
OK No errors are currently detected.
ERR Frame bit errors, CRC errors, or BPVs are detected.
LOS A loss of signal condition exists.
OOF An out of frame condition exists.
RAI Far end is receiving a remote alarm indication signal.
AIS The far end is receiving an alarm indication signal.
UAS An unavailable signal state exists due to consecutive
severely errored seconds.
Port
Parameters
page 3-12
Alarm
Parameters
page 3-11
TCP/IP
Parameters
page 3-14
Configuration Menu
Management
Parameters
page 3-16
DBU
Parameters
page 3-13
Summary
page 3-17
SNMP
Parameters
page 3-15
Figure 3-10 Configuration Menu
Line
Parameters
page 3-10
Network Interface Framer /Deframer Multiplexor Receivers /Drivers
Receivers/Drivers
BERT Generator/
Detector
EIA 530 or V.35
(100' max.)
Framer /Deframer
DTE (DSX1)
RJ48C
DSX1, 1'-655'
to cross-connect
From
NET
To
NET
To
NET
From
NET
5
4
2
1
T1 DTE
LLB
To Network
From Network
RJ48C
5
4
2
1 To
Ports
From
Ports
Network Interface Framer /Deframer Multiplexor Receivers /Drivers
Receivers/Drivers
BERT Generator/
Detector
EIA 530 or V.35
(100' max.)
Framer/Deframer
DTE (DSX1)
RJ48C
DSX1, 1' -655'
to cross-connect
To
NET
From
NET
From
NET
To
NET
5
4
2
1
To Network
From Network
RJ48C
5
4
2
1 To
Ports
From
Ports
DTE
Near/Far
DTE LLB
Port Loop (bidirectional)