N in, Figure 178 – H3C Technologies H3C MSR 50 User Manual
Page 196
175
Figure 178 Adding a blacklist entry for Host D
•
Enter IP address 5.5.5.5, the IP address of Host D.
•
Select Permanence for this blacklist entry.
•
Click Apply.
•
Click Add and then perform the following configurations, as shown in
:
Figure 179 Adding a blacklist entry for Host C
•
Enter IP address 192.168.1.5, the IP address of Host C.
•
Select Hold Time and set the hold time of this blacklist entry to 50 minutes.
•
Click Apply.
# Configure intrusion detection: Enable scanning attack protection, and enable blacklist function for it;
enable Land attack protection and Smurf attack protection.
•
Select Security Setup > Attack Defend > Intrusion Detection from the navigation tree and then
perform the following configurations, as shown in
.