Grass Valley PFR 500/E Dec 10 2001 - Manual (Page 36)

Chapter 2 Installing a PFC500/E
36 PFC500/E Instruction Manual November 17, 2000
The valid FC-AL address ID range is a number 0 through 125 decimal, which is 0
through 7D hexadecimal. The following figures and table locate the switches and
show how to select ID numbers using them.
RC FC-AL address ID switches
3. Set the PFC500’s chassis address (CA) switch to 0 using the tip of a pen or a paper
clip as shown in the following illustration.
To access the CA switch, you must open the PFC 500/E’s front door. The chassis
address, referred to as the back-end address, identifies the PFC500/E and
determines disk module addresses. The PFC 500 chassis address must be set to 0.
B
E X P
Location of switches
For address ID Set top switch to Set bottom switch to
0 0 0
1 0 1
.
.
. .
.
. .
.
.
15 0 F
16 1 0
.
.
. .
.
. .
.
.
29 1 D
Chassis
address lights
Increment button
Push to increase address.
Decrement button
Push to decrease address.
Address
switch
NOTE: The address
switch has 16 posi-
tions, 12 are marked
0 through 11 and the
remaining 4 are
marked with a dash
(-). A dash position
is equivalent to the 0
position.
00
1
2 3
4 5
12
3
0
6 7
8 9
10 11
0