Grass Valley PFR 500/E Dec 10 2001 - Manual (Page 38)

Chapter 2 Installing a PFC500/E
38 PFC500/E Instruction Manual November 17, 2000
6. From the back of the cabinet, plug the ac line cord into each power supply and turn
on the supply’s power, as shown next.
7. Re-install the drive fan pack in the back of the PFC 500/E.
You can install the drive fan pack in either horizontal position. However, for a
consistent image with all PFC 500/Es, we recommend you install it with the status
light in the upper right corner as shown below.
A
B
E
X
P
A
B
E
X
P
A
B
E X P
A
B
E X P
Bottom power supply
Top power supply
ac power cord
(right-angle plug)
Channel
ac inlet
Power switch and
circuit breaker Power switch and
circuit breaker
ac inlet
Channel
ac power cord
(right-angle plug)
A. Insert the right-angle plug on the ac line cord into the supply’s ac inlet
For each power supply:
B. Route the cord along the power supply to the side of the chassis.
IMPORTANT: The cord must not occupy the drive fan pack space.
C. Bend the cord into a U shape and slide the U into the channel so the end of
the cable comes out of the channel at the back of the chassis.
D. Plug the end of the cord into one of the cabinet’s power outlets.
E. Set the supply’s power switch to the on (1) position.
A
B
E
X
P
A. Grasp the latches on the
drive fan pack.
B. Squeeze the latches
together and gently push
the fan pack into the
chassis until it clicks in
place.