Grass Valley PFR 500/E Dec 10 2001 - Manual (Page 63)

Replacing or adding a power supply module
November 17, 2000 PFC 500/E Instruction Manual 63
To remove a power supply filler module
1. Remove the drive fan pack as shown on page 60.
2. Remove the power supply filler module as shown.
Continue to the power supply installation procedure (page 67) to install the add-on
power supply in the slot from which you removed the filler module.
A
B
E
X
P
A
B
E
X
P
A
B
E
X
P
A
B
E
X
P
A. Push the latches on both sides of
the filler module towards the center
of the module.
B. Pull the filler module from the slot.
Bottom filler module
Latch
(1 per side)
A
B
E
X
P
A
B
E
X
P
A
B
E
X
P
Top filler module
Latch
(1 per side)
A. Push the latches on both sides of
the filler module towards the center
of the module.
B. Pull the filler module from the slot.