Grass Valley PFR 500/E Dec 10 2001 - Manual (Page 69)

Replacing or adding a power supply module
November 17, 2000 PFC 500/E Instruction Manual 69
2. Plug the ac power cord into the new supply, and turn on the power supply as shown
here.
3. Reinstall the drive fan pack as shown on page 60.
A
B
E
X
P
A
B
E
X
P
A
B
E X P
A
B
E X P
Bottom power supply Top power supply
ac power cord
(right-angle plug)
Channel
ac inlet
Power switch and
circuit breaker Power switch and
circuit breaker
ac inlet
Channel
ac power cord
(right-angle plug)
A. Insert the right-angle plug on the ac line cord into the supply’s ac inlet
For each power supply:
B. Route the cord along the power supply to the side of the chassis.
IMPORTANT: The cord must not occupy the drive fan pack space.
C. Bend the cord into a U shape and slide the U into the channel so the end of
the cable comes out of the channel at the back of the chassis.
D. Plug the end of the cord into one of the cabinet’s power outlets.
E. Set the supply’s power switch to the on (1) position.