To set the datum in a specific axis, 5 setting the datum with the 3d touch probe system, Yx z – HEIDENHAIN TNC 360 User Manual User Manual

Page 52

Advertising
To set the datum in a specific axis, 5 setting the datum with the 3d touch probe system, Yx z | HEIDENHAIN TNC 360 User Manual User Manual | Page 52 / 237 To set the datum in a specific axis, 5 setting the datum with the 3d touch probe system, Yx z | HEIDENHAIN TNC 360 User Manual User Manual | Page 52 / 237
Advertising
See also other documents in the category HEIDENHAIN Equipment: