HEIDENHAIN TNC 360 User Manual - Manual (Page 144)

TNC 360 7-10
7 Programming with Q Parameters
e.g.
e.g.
Q
7.5 Checking and Changing Q Parameters
Q parameters can be checked during program run or during a test run, and
changed if necessary.
Preparation:
• A running program must be aborted (e.g. press machine STOP button
and STOP key)
• If you are doing a test run, you must interrupt it
To call a Q parameter:
Q =
Select desired parameter (in this example, Q10).
Q10 = + 100
The TNC displays the current value.
Change Q parameter (in this example, Q10 is changed to 0).
Leave the Q parameter unchanged.
1 0
ENT
0
ENT
ENT