Programs -19, Program directory, 5 programs – HEIDENHAIN TNC 360 User Manual User Manual
Page 37
TNC 360
1-19
1
Introduction
1.5 Programs
The TNC 360 can store up to 32 part programs at once. The programs can
be written in HEIDENHAIN plain language dialog or according to ISO. ISO
programs are indicated with “ISO”.
Each program is identified by a number with up to eight characters.
Program directory
The program directory is called with the PGM NR
key. To erase programs in TNC memory, press the
CL PGM key.
The program directory provides the following
information:
• Program number
• Program type (HEIDENHAIN or ISO)
• Program size in bytes, where one byte is the
equivalent of one character.
PGM
NR
PGM
NR
PGM
NR
PGM
NR
CL
PGM
Fig. 1.24:
Program management functions
Fig. 1.25:
Program directory on the TNC screen
Action
Mode of
Call program
operation
directory with ...
Create (a program)
...
Edit
...
Erase
...
Test
...
Execute
...