HEIDENHAIN TNC 360 User Manual - Manual (Page 236)

TNC 360 12-26
12 Tables, Overviews, Diagrams
STYLUS ALREADY IN CONTACT
Pre-position the touch probe so that the stylus cannot be deflected before
it reaches the RANGE.
TIME LIMIT EXCEEDED
Enter a TIME LIMIT that is appropriate to the 3D surface to be scanned
(CONTOUR LINES cycle).
TOUCH POINT INACCESSIBLE
• The stylus must not be deflected before it reaches the RANGE.
• The stylus must be deflected somewhere within the RANGE.
WRONG AXIS PROGRAMMED
Enter calibrated touch probe axis in the RANGE cycle.
12.6 TNC Error Messages