HEIDENHAIN TNC 360 User Manual - Manual (Page 112)

TNC 360 5-28
5 Programming Tool Movements
P
5.5 Path Contours – Polar Coordinates
L COORDINATES?
Select polar coordinates.
POLAR COORDINATES RADIUS PR?
Enter the radius from the pole to the straight line end point, for
example PR = 5 mm.
POLAR COORDINATES ANGLE PA?
Enter the angle from the reference axis to PR, for example PA = 30°.
If necessary, enter also:
Radius compensation
Feed rate
Miscellaneous function
Resulting NC block: LP PR+5 PA+30
5 e.g.
0 3 e.g.
ENT
ENT