HEIDENHAIN TNC 360 User Manual - Manual (Page 44)

TNC 360 2-6
2 Manual Operation and Setup
0
100
150 50
S %
0
100
150 50
F %
e.g.
6
ENT
2.2 Spindle Speed S, Feed Rate F and Miscellaneous Function M
To enter the miscellaneous function M:
Select the STOP function.
MISCELLANEOUS FUNCTION M ?
Enter the desired miscellaneous function M.
Activate the miscellaneous function M with the machine START key.
Chapter 12 provides an overview of the miscellaneous functions.
To change the spindle speed S:
Turn the spindle speed override knob:
Adjust the spindle speed S to between 0% and 150% of the last entered
value.
The spindle speed override will function only if your machine tool is equipped with a stepless spindle drive.
To change the feed rate F:
In the MANUAL OPERATION mode the feed rate is set through a machine
parameter.
Turn the feed rate override knob:
Adjust the feed rate to between 0% and 150% of the last entered value.
STOP
I