HEIDENHAIN TNC 360 User Manual - Manual (Page 29)

TNC 360 1-11
1 Introduction
Absolute workpiece positions
Each position on the workpiece is clearly defined by its absolute coordi-
nates.
Example: Absolute coordinates of the position ➀:
X = 20 mm
Y = 10 mm
Z = 15 mm
If you are drilling or milling a workpiece according to a workpiece drawing
with absolute coordinates, you are moving the tool to the coordinates.
Incremental workpiece positions
A position can be referenced to the previous nominal position: i.e. the
relative datum is always the last programmed position. Such coordinates
are referred to as incremental coordinates (increment = growth), or also
incremental or chain dimensions (since the positions are defined as a
chain of dimensions). Incremental coordinates are designated with the
prefix I.
Example: Incremental coordinates of the position ➂
referenced to position ➁
Absolute coordinates of the position ➁ :
X = 10 mm
Y = 5 mm
Z = 20 mm
Incremental coordinates of the position ➂ :
IX = 10 mm
IY = 10 mm
IZ = –15 mm
If you are drilling or milling a workpiece according to a workpiece drawing
with incremental coordinates, you are moving the tool by the coordinates.
An incremental position definition is therefore intended as an immediately
relative definition. This is also the case when a position is defined by the
distance-to-go to the target position (here the relative datum is located at
the target position). The distance-to-go has a negative algebraic sign if the
target position lies in the negative axis direction from the actual position.
The polar coordinate system can also express both
types of dimensions:
• Absolute polar coordinates always refer to the
pole (CC) and the reference axis.
• Incremental polar coordinates always refer to
the last programmed nominal position of the
tool.
Fig. 1.17: Position definition through
absolute coordinates
Fig. 1.18: Position definition through
incremental coordinates
Y
X
Z
1
20
10
Z=15mm
X=20mm
Y=10mm
15
I
Z=–15mm
Y
X
Z
2
10
5 5
15
20
10
10
I X=10mm
I
Y=10mm
3
0
0
Fig. 1.19: Incremental dimensions in polar coordinates (designated
with an "I")
X+
Y+
10
CC
0
°
30
PR
PR
PR
+IPR
+IPA +IPA
PA
1.2 Fundamentals of NC