HEIDENHAIN TNC 128 (77184x-01) - Manual (Page 393)

HEIDENHAIN TNC 128 393
16.5 BORING (Cy
c
le 202)
16.5 BORING (Cycle 202)
Cycle run
1 The TNC positions the tool in the spindle axis at rapid traverse
FMAX to the set-up clearance above the workpiece surface.
2 The tool bores to the programmed depth at the feed rate for
plunging.
3 If programmed, the tool remains at the hole bottom for the entered
dwell time with active spindle rotation for cutting free.
4 The TNC then orients the spindle to the position that is defined in
parameter Q336.
5 If retraction is selected, the tool retracts in the programmed
direction by 0.2 mm (fixed value).
6 The TNC moves the tool at the retraction feed rate to the set-up
clearance and then, if entered, to the 2nd set-up clearance at
FMAX. If Q214=0, the tool point remains on the wall of the hole.