HEIDENHAIN TNC 128 (77184x-01) - Manual (Page 84)

84 Programming: Fundamentals, file management
3.2 Cr
eating and wr
iting pr
ogr
a
ms
Possible feed rate input
Functions for setting the feed rate Soft key
Rapid traverse, non-modal. Exception.
Traverse feed rate automatically calculated in
TOOL CALL
Move at the programmed feed rate (unit of
measure is mm/min or 1/10 inch/min). With
rotary axes, the TNC interprets the feed rate in
degrees/min, regardless of whether the program
is written in mm or inches
Define the feed per revolution (units in mm/rev or
inch/rev). Caution: In inch-programs, FU cannot
be combined with M136
Define the tooth feed (units in mm/tooth or
inch/tooth). The number of teeth must be defined
in the tool table in the CUT. column
Functions for conversational guidance Key
Ignore the dialog question
End the dialog immediately
Abort the dialog and erase the block