Yaskawa 1000 Series Drive Option - CC-Link Installation - Manual (Page 16)

5 Installation Procedure
16 YASKAWA ELECTRIC TOBP C730600 44A YASKAWA AC Drive-Option Card CC-Link Installation Manual
◆
Prior to Installing the Option Card
Prior to installing the DeviceNet Option, wire the drive and make necessary connections to
the drive terminals. Refer to the Quick Start Guide for the drive the CC-Link Option is
connected to for information on wiring and connecting the drive. Verify that the drive runs
normally without the option installed.
◆
Installing the CC-Link Option
This CC-Link Option can be inserted into the either only CN5-A connectors located on the
drive’s control board.
See the drive manual for directions on removing the front cover.
1.
Shut off power to the drive, wait the appropriate amount of time for voltage to
dissipate, then remove the operator and front cover.
2.
Insert the CN5 connector on the CC-Link Option into the matching CN5 connector
on the drive, then fasten it into place using one of the screws included with the CC-
Link Option.
Connect one of the lead lines using one of the screws to the ground terminal.
Three separate lead lines have been included with the CC-Link Option to connect to
three separate ports. Use the lead line with the length appropriate for the distance of
the port.
Note: There are only two screw holes on the drive for ground terminals. If three option cards are
connected, two of the lead lines will need to share the same ground terminal.
Figure 4
REV
DRV LERR
FOUT
G
A
E
F
I
J
B
C
D
H
K