Yaskawa SI-EP3 PROFINET Installation - Manual (Page 33)

7 Web Interface
YASKAWA TOEP YEACOM 07A 1000-Series Option PROFINET SI-EP3 Installation Manual 33
■ Network Tab
The Network tab shows the status of the option network traffic and the status of open I/O
connections.
Figure 14
Figure 15 Network Tab View
Table 9 Network Monitor Descriptions
Network Monitor Explanation
Msg Tx OK Cumulative number of messages transmit successfully from SI-EP3.
Msg Rx OK Cumulative number of messages received successfully to SI-EP3.
Current Connections Current number of open connections.
Control Connection Delta
Time The time between the last two writes to the Control register, MEMOBUS/Modbus
address 0001H.
Msg Tx Dropped
Cumulative number of messages dropped due to output network buffer being full and
unable to hold the new message.
Msg Rx Dropped
Cumulative number of messages dropped due to input network buffer being full and
unable to hold the new message.
Collisions
Cumulative number of collisions (half duplex only) reported by the MAC/PHY
(Media Access Control/Physical Connection).
Msg Tx Errors
Cumulative number of transmit underruns and transmit stops reported by the
MAC/PHY.
Msg Rx Errors
Cumulative number of receive overruns, receive stops, and receive error frames
reported by the MAC/PHY.
Tx Retry
Cumulative number of transmits in which the 1st attempt was delayed due to busy
medium reported by the MAC/PHY.
Note: Cumulative counters are reset when the power supply is cycled.