Yaskawa P7 to P1000 - Manual (Page 39)

13 Appendix 2 Parameter Cross Reference
YASKAWA PL.P1000.01 P7 to P1000 - Product Transition Guide 39
Multi-Function
Analog Output
Analog Output 1
Terminal FM
Monitor
Selection
H4-01 2 H4-01 102
53: PI Feedback 2 505: PI Feedback 2
— 506: PI Differential Feedback
— 514: PI Output 2 (U4)
— 515: PI Output 2 (L4)
— 517: PI2 Set-point
— 518: PI2 Feedback
— 519: PI Input 2
— 520: Output
— 599:PID Setpoint Command
— 618: PG1 Couter Value
— 619: PG2 Counter Value
— 620: UP/DOWN 2 Bias
— 621: Offset Frequency
Note: 100% = 10 Vdc output
FM gain setting (H4-02).
—
Multi-Function
Analog Output
Analog Output 1
Terminal FM
Gain
H4-02 100% H4-02 100.0% —
Analog Output 1
Terminal FM
Bias
H4-03 0.0% H4-03 0.0% —
Analog Output 2
Terminal AM
Selection
H4-04 8* H4-04 103* *Refer to parameter H4-01 for details.
Analog Output 2
Terminal AM
Gain
H4-05 50.0% H4-05 50.0% —
Analog Output 2
Terminal AM
Bias
H4-06 0.0% H4-06 0.0% —
Analog Output 1
Signal Level
(FM) Selection
H4-07 0 H4-07 0
H4-07 H4-07
0: 0 to +10 V output 0: 0 to +10 Vdc output
— 1: -10 to 10 Vdc output
2: 4 to 20 mA* 2: 4 to 20 mA
Analog Output 2
Signal Level
(AM) Selection
H4-08 0 H4-08 0
H4-08 H4-08
0: 0 to +10 V output 0: 0 to +10 Vdc output
— 1: -10 to 10 Vdc output
2: 4 to 20 mA* 2: 4 to 20 mA
* An analog output of 4-20mA
cannot be used with the
standard terminal board. A
terminal board with a shunt
connector CN15 is needed,
part ETC.
Parameter Name
P7 P1000 Setting
Parameter Default Parameter Default P7 P1000