Yaskawa P7 to P1000 - Manual (Page 43)

13 Appendix 2 Parameter Cross Reference
YASKAWA PL.P1000.01 P7 to P1000 - Product Transition Guide 43
Overtorque
Detection
Torque
Detection
Selection 1
L6-01 0 L6-01 0
6: UL3 detection always active
during run, operation continues
after detection 6: UL3 detection always active
during run, operation continues
after detection
7: UL3 detection only active
during speed agree, output
shuts down on an oL3 fault 7: UL3 detection only active
during speed agree, output shuts
down on an oL3 fault
8: UL3 detection always active
during run, output shuts down
on an oL3 fault 8: UL3 detection always active
during run, output shuts down on
an oL3 fault
—
9: UL6 detection only active
during speed agree, operation
continues after detection
—
10: UL6 detection always active
during run, operation continues
after detection
—
11: UL6 detection only active
during speed agree, output shuts
down on an oL3 fault
—
12: UL6 detection always active
during run, output shuts down on
an oL3 fault
Torque
Detection Level
1
L6-02 15% L6-02 15% —
Torque
Detection Time 1
L6-03 10.0 s L6-03 10.0 s —
Hardware
Protection
Internal
Dynamic
Braking Resistor
Protection
Selection (ERF)
L8-01 0 L8-01 0
L8-01 L8-01
0: Not Provided 0: Disabled
1: Provided 1: Enabled
Overheat
Pre-Alarm Level
L8-02 95 °C L8-02 * *Determined by drive capacity parameter o2-04.
Overheat Pre-
Alarm Operation
Selection
L8-03 3 L8-03 3
L8-03 L8-03
0: Ramp to stop 0: Ramp to stop
1: Coast to stop 1: Coast to stop
2: Fast Stop 2: Fast Stop
3: Alarm Only
3: Continue operation
(Alarm triggered)
—
4: Continue operation at reduced
speed as set in L8-19
Input Phase Loss
Detection Level
L8-06
KVA
Dep.
N/A — —
Output Ground
Fault Detection
Selection
L8-09 1 L8-09 1*
L8-09 L8-09
0: Disabled 0: Disabled
1: Enabled 1: Enabled
*Determined by drive capacity parameter o2-04.
Heatsink
Cooling Fan
Operation
Selection
L8-10 0 L8-10 0
L8-10 L8-10
0: During run only 0: During run only
1: Fan always on 1: Fan always on
Parameter Name
P7 P1000 Setting
Parameter Default Parameter Default P7 P1000