Yaskawa VS mini J7 Series - Manual (Page 112)

112
CE Conformance - Electro-Magnetic Compatibility (EMC)
Compliance
In order to conform to EMC standards, exclusive-use methods are required for line
filter application, cable shielding and inverter installation. An outline of the methods
follows.
The line filter and the inverter must be mounted on the same metal plate. The filter
should be mounted as close to the inverter as practical. Keep cable as short as possible.
The metal plate should be securely grounded. The ground of the line filter and inverter
must be bonded to the metal plate with as much area as possible.
For line power input cable, screened cable is recommended at least within the panel.
The screen of the cable should be connected to a solid ground. For the motor cable,
screened cable (max. 20m) must be used and the screen of the motor cable is connected
to ground at both ends by a short connection, using as large an area as practical.
For a more detailed explanation, please refer to Making YASKAWA Inverter Products
Conform with EMC Directive (G-TI#99012-V7).
The following table and figures show the line filter list for EMC standards and the
installation/wiring of inverter and line filter.
Line Filter List for EMC Conformance
Recommended Line Filters for VS mini J7 made by Rasmi Electronics Ltd
(200V single phase)
Rated Voltage: AC 250V single phase
Ambient Temperature: 40
°
C (max.)
VS mini J7 Model
Current
(A)
Weight
(kg)
Dimension
W
×
D
×
H
CIMR-J7AUB0P1
CIMR-J7AUB0P2 RS 1010-J7 10 0.6 71 x 45 x 169
CIMR-J7AUB0P4
CIMR-J7AUB0P7 RS 1020-J7 20 1.0 111 x 50 x 169
CIMR-J7AUB1P5
CIMR-J7AUB2P2 RS 1030-J7 30 1.1 144 x 50 x 174
CIMR-J7AUB3P7 RS 1040-J7 40 1.2 174 x 50 x 174