Yaskawa VS mini J7 Series - Manual (Page 46)

46
Open the front cover and verify that the strip length is 0.22 in. (5.5mm)
• Wiring Inspection
After completing wiring, check the following:
• Wiring is properly connected.
• Wire clippings or screws are not left inside the unit.
• Screws are securely tightened.
• Bare wires in the terminal do not come in contact with other terminals.
If the FWD (REV) run command is given during the operation reference selec-
tion (n02=1) from the control circuit terminal, the motor will start automatically
after the main circuit input power supply is turned ON.