Casio XJ-A142 User Guide - Manual (Page 9)

9
Getting Ready
This section explains how to select a location for the projector, how to connect its cables, and how to
perform other operations required before using it.
Locate the projector on a desk, table, or stand that is firm and level. Make sure that you allow
sufficient space around the sides and back of the projector for proper ventilation. The illustrations
below show how the projector should be oriented relative to the screen for optimum projection.
Important!
z With an XJ-A Series Projector, the allowable vertical angle range when setting up is ±30
degrees (Figure 1). Make sure the projector is within this range. Setting up the projector
outside this vertical angle range can shorten lamp life. There is no limit on the horizontal angle
of the projector (Figure 2).
z With an XJ-M Series Projector, there is no limit on the vertical and horizontal setup angle.
Setting Up the Projector
XJ-A242/XJ-A247/XJ-A252/XJ-A257/
XJ-M241/XJ-M246/XJ-M251/XJ-M256
Other models
Position the projector so the lens side is at the edge of the table,
etc. Make sure the projector is at a right angle to the screen.
Figure 1 Figure 2
Screen Screen