Enterasys Networks VHSIM2-A6DP - Manual (Page 37)

Using Local Management Screens
Local Management 3-3
Figure 3-1 Example of a Local Management Screen
The following list explains each of the Local Management fields:
Event Message Field
This field briefly displays messages that indicate if a Local Management procedure was executed
correctly or incorrectly, that changes were saved or not saved to Non-Volatile Random Access
Memory (NVRAM), or that a user did not have access privileges to an application.
NOTE: Only the password, configuration and status screens have event message
fields.
Physical Interface 25 ATM Redundancy Configuration
Device Name:XXXXX-XX
Slot Number:X
Flash Image Revision: XX.XX.XX
BOOTPROM Revision: XX.XX.XX
RETURN SAVE EXIT
XXXXX-XX LOCAL MANAGEMENT
Redundancy Status: [Enabled]
Primary port: 1 Active port: 1
Activation of redundant port: [Automatic]
Revert to Primary port: [Automatic]
Periodic test status: [Enabled] Periodic test time: 01:00.00
Result of previous test: [ ] No test performed since system startup
TEST PORTS NOW RESET TO FACTORY DEFAULTS
NOTE:
This shows the location of the cut away that is used in most of the screen graphics in this document. The top portion on the screen is
cut away to eliminate repeating the same information in each graphic. The screen title is contained in its figure title.
28251_08
Event Message Line
Event Message Field
Display Field
Input Field
Command Fields
Selection/Toggle
Fields
See Note